Advertisement
Charging
1. Turn Power Switch in the 'off' position.
2. Do not plug the charger into the outlet first, for safety reasons plug the charger cord into the
scooter first, then into a 110 V outlet.
3. Charge your scooter for 6-8 hours. The LED will be red during charging and once it is fully
complete the LED will turn to green.
4. Do not overcharge you battery this may limit the life of your battery. Unplug after 8 hours to
avoid overheating.
5. Charge unit when a yellow or red light appears and every 90 days.
Battery Instructions
1. Do not touch the battery liquid solution, if you come in contact with the solution flush the
effected area with water. If you must come in contact with battery wear gloves.
2. Change the battery if there are any leaks, visible breaks or cracks.
3. Dispose of the battery according to your state and local laws.
4. Periodically check your battery with a voltage meter. Each battery should read 26-24V.
Fold Handle Bars Down
1. Lift the Folding Quick Release lever and unscrew the Folding Quick Release bolt. Position
yourself in front of your scooter and lift up on the base of the deck; the Handle Bar will fold
down.
2. Lay the Handle Bar down on top of the deck and tighten the Folding Quick Release bolt.
3. To protect the Grips from potential damage unscrew the star screws and lock washers on the
'T' of the Handle Bar and lay the Grips down. Make sure not to lose the screws and washers.
Adjust the Height of the Handle Bar
1. Unclamp the Handle Bar Quick Release.
2. Lift the Handle Bar up or down, as needed so that the Handle Bar is at waist height; or adjust
to the height that you feel comfortable and are in best control of your scooter.
3. Secure the pin into designated hole and clamp the Handle Bar Quick Release to secure the
Handle Bar into place.
Maintenance
1. Inspect your scooter before every use; check the brake, throttle, drive belt, and tires. Make
sure that all parts are in working order and are not damaged.
2. Clean your scooter regularly by wiping it down with a damp rag. This scooter is electric;
exposure to water may permanently damage your scooter.
Squeeze Brake Handle on Left Controller and push the scooters to see if it rolls
Brake
easily. If so you will need to tighten the brake. Tighten bolt until the scooter will
not move with the brakes applied; if not see instructions on how to adjust the brake
on page 11, figure 10.
While the scooter is Off (O) apply the Throttle and release; check to make sure that
Throttle
the Throttle springs back to stop after you release it.
Drive Belt
The drive belt is located on the right side of the rear tire. Check to make sure that
there is no visual damage and that the belt is aligned on the sprocket attached to
rear tire.
Check for wear, that the bolts are securely fastened, and that they are in alignment.
Tires
7
Advertisement
