Download Print this page

Troubleshooting Chart; Low Battery - Rad2Go ZZ Cruiser Owner's Manual

Advertisement

Problem
The power light by the on/off
switch does not light up
when the scooter is turned on.
The power lights by the
on/off switch light up but
scooter still does not work.
Clicking noise coming from
motor.
When the Brake Lever is
squeezed my scooter does not
stop.
My scooter is going slower,
and slower, and slower. What
is going on?

Troubleshooting Chart

Cause
1. Battery is discharged.
2. Loose connection inside the
scooter.
1. The Throttle handle is not
operating properly.
1. Brush in Motor has come
loose.
1. The brakes have not been
adjusted properly.

1. Low Battery

2. Battery is defective
Solution
1. Recharge your
scooter.
2. Remove (3) screws
that hold the deck on
and remove the deck.
Visually inspect all
wire connections
making sure there are
no loose wires,
reconnecting those
that are.
1. Replace the Throttle
Handle. Call
Customer Service at
(800) 498-8455 to
order a new Throttle.
1. Replace Motor. Call
Customer Service at
(800) 498-8455 to
order a new 300 W
Motor.
1. Adjust the Brake by
loosening the bolt on
the rear brake wheel
and pull the cable and
retightening the bolt.
1. Recharge your
Battery for 6-8
Hours.
2. Replace Battery. Call
Customer Service at
(800) 498-8455 to
order a new 24.0V
(2x12V) Battery.
13

Advertisement

loading

This manual is also suitable for:

Cwt-024cXyd-24