Call Channel; Recalling The Call Channel; R C C; Eprogramming The Channel Display - Kenwood TM-481A Instruction Manual

CALL CHANNEL

Call Channel default settings:
• On M market models, pressing [CALL] changes the
transceiver to the Call Channel.
The Call Channel can be recalled instantly no matter
what frequency the transceiver is operating on. For
instance, you may use the Call Channel as an
emergency channel within your group. In this case, Call
Scan {page 41} will be useful.
The default Call Channel frequency is as follows;
TM-281A: 144.000 MHz
TM-481A: 440.000 MHz
Note: Unlike Memory Channels 0 to 199, the Call Channel cannot
be cleared.
R C C
ECALLING THE ALL

HANNEL

1 Press [CALL] to recall the Call Channel.
• The Call Channel frequency and "C" appear.
• To return to the previous frequency, press [CALL] again.
R C C
EPROGRAMMING THE ALL
1 Select your desired frequency and related data (Tone,
CTCSS, DCS, or offset direction, etc.).
HANNEL
• When you program the Call Channel as an odd-split
channel, select a reception frequency first.
2 Press [F].
• A Memory Channel number appears and blinks.
3 Turn the Tuning control or press Mic [UP]/[DWN] to
select the Call Channel ("C").
4 Press [MR].
• The selected frequency and related data are stored in the
Call Channel.
To also store a separate transmit frequency, continue with the following
steps:
5 Select the desired transmission frequency.
6 Press [F].
7 Turn the Tuning control or press Mic [UP]/[DWN] to
select the Call Channel ("C").
8 Press [MR] (1s).
• The separate transmission frequency is stored in the Call
Channel.
Note:
When you recall an odd-split Call Channel, "+" and "–" appear on
◆
the display.
Transmit offset status and Reverse status are not stored in an
◆
odd-split Call Channel.
7
35