Disconnecting From Your Computer; Charging The Battery - Packard Bell COMPASSEO User Manual

2.3 Disconnecting from your Computer

1. Click on the Safely Remove Hardware icon
2. Click on Safely remove USB Mass Storage Device.
3. Wait until a Safe to Remove Hardware message is displayed.
4. Remove the device.

2.4 Charging the Battery

You are recommended to fully charge the battery each time the device is completely discharged. This will
ensure maximum performance. Avoid frequent full discharges, because this puts additional strain on the
battery. Several partial discharges with frequent recharges are better for lithium-ion than one deep one.
When the battery is too low, be sure to charge it in time. Otherwise, the device may automatically
turn off and cannot be turned on. If your device becomes fully discharged and cannot be started,
follow the procedure below.
1. Connect the device to the computer for at least 20 minutes before tuning it on.
Note: when charging using the cigarette lighter adapter or the AC adapter (optional), you need to
connect the device for at least 10 minutes before turning it on.
2. After this short period, the battery should be sufficiently charged to allow the device to operate
normally when connected to the computer, cigarette lighter adapter or AC adapter.
Charging with the computer:
Connect the supplied USB cable to one of your computer's USB ports. The device will automatically
charge.
Note: It may take up to 2.5 hours to fully charge the device.
in the Notification area (next to the clock).
8