Disconnecting From Your Computer; Charging The Battery - Packard Bell GPS 400 User Manual

2.3 Disconnecting from your Computer

1. Click on the Safely Remove Hardware icon
2. Click on Safely remove USB Mass Storage Device.
3. Wait until a Safe to Remove Hardware message is displayed.
4. Remove the device.

2.4 Charging the Battery

The charging LED indicates the status of battery:
Red blinking: battery has less than 10% (with beep sound)
Static amber: charging
Static green: fully charged
The charging indicator (the last two) works only when AC power is present.
You are recommended to fully charge the battery each time the device is completely discharged. This will
ensure maximum performance. Avoid frequent full discharges, because this puts additional strain on the
battery. Several partial discharges with frequent recharges are better for lithium-ion than one deep one.
When the battery is too low, be sure to charge it in time. Otherwise, the device may automatically
turn off and cannot be turned on. If your device becomes fully discharged and cannot be started,
follow the procedure below.
1. Connect the device to the AC adapter for at least three minutes before tuning it on.
2. After this short period, the battery should be sufficiently charged to allow the device to operate
normally when connected to the AC adapter or computer.
Charging with the AC adapter:
Connect the AC adapter to the power connector. The device will automatically charge.
Full charge in power-off mode requires about 4 hours.
Charging with the cigarette lighter adapter:
You can plug in the cigarette lighter adapter to charge the GPS 400 in your car.
in the Notification area (next to the clock).
8