Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Packard Bell Compasseo 800
Summary of Contents for Packard Bell Compasseo 800
- Page 1 Packard Bell Compasseo 800 Disassembly Manual...
-
Page 2: Table Of Contents
Removing the GPS antenna (A) ................5 Removing the GPS module (B) ................6 Removing the main board ..................6 Removing the Bluetooth module (C) (see fig. 3)............7 Removing the speaker (see fig. 3)................7 Removing the speaker bracket.................7 Reassembly Notes ....................9 Notice ........................10 Compasseo 800 Disassembly Manual... -
Page 3: Overview
The instructions are illustrated where necessary with images of the part of the device that is being removed or disassembled. Packard Bell reserves the right to make changes to the Compasseo 800 without notice. Technician Notes Only technicians authorized by Packard Bell B.V. should attempt to repair this equipment. -
Page 4: Opening The Case
Fig. 1 Bottom of the device 2. Remove the four rubber stoppers from the holes in the corners at the back of the device. 3. Remove the four screws left in the holes. Fig. 2 Removing screws Compasseo 800 Disassembly Manual... -
Page 5: Removing The Battery
1. Gently disconnect the GPS antenna from the GPS board. In case the cable does not loosen easily, use a small flat screwdriver to push the connector out of the GPS board connector. 2. Slide the GPS antenna upwards out of its holder. Compasseo 800 Disassembly Manual... -
Page 6: Removing The Gps Module (B)
Bluetooth module. Do not directly pull away the main board, as the cable and microphone casing are still attached! 3. Disconnect the LCD cable and the microphone. Fig. 4 Disconnecting the LCD cable Compasseo 800 Disassembly Manual... -
Page 7: Removing The Bluetooth Module (C) (See Fig. 3)
1. Remove the two screws on the left and right side of the speaker. 2. Lift the speaker and disconnect the speaker cable from the main board. Removing the speaker bracket Remove the speaker bracket as follows: Compasseo 800 Disassembly Manual... - Page 8 Note Make sure that by putting back the speaker bracket, the Bluetooth cable needs to be reconnected first, as this cable goes underneath all other parts. Compasseo 800 Disassembly Manual...
-
Page 9: Reassembly Notes
7. You can now put back the main board into the casing by reconnecting the flat cable and microphone cable and attaching the main board to the casing. 8. Put back the remaining parts of the device and close. Compasseo 800 Disassembly Manual... -
Page 10: Notice
Packard Bell B.V. PACKARD BELL B.V. SHALL NOT BE LIABLE FOR TECHNICAL OR EDITORIAL ERRORS OR OMISSIONS CONTAINED HEREIN; NOR FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE FURNISHING, PERFORMANCE, OR USE OF THIS MATERIAL.