Solving Problems; Self-Test Feature Check (Stfc) - Dell 1908WFP User Manual

Solving Problems: Dell 1908WFP Flat Panel Monitor User's Guide
Back to Contents Page

Solving Problems

Dell™ 1908WFP Flat Panel Monitor User's Guide
Troubleshooting Your Monitor
General Problems
Product Specific Problems
Universal Serial Bus Specific Problems
Dell™ Soundbar Troubleshooting
CAUTION: Before you begin any of the procedures in this section, follow the
Troubleshooting Your Monitor

Self-Test Feature Check (STFC)

Your monitor provides a self-test feature that allows you to check whether your monitor is functioning properly. If your monitor and computer are properly connected but the monitor screen
remains dark, run the monitor self-test by performing the following steps:
1. Turn off both your computer and monitor.
2. Unplug the video cable from the back of the computer. To ensure proper Self-Test operation, remove both Digital (white connector) and the Analog (blue connector) cables from the
back of computer.
3. Turn on the monitor.
The floating 'Dell Self-test Feature Check' dialog box should appear on-screen on a black background if the monitor cannot sense a video signal and is working correctly.
While in self-test mode, the power LED remains green. Also, depending upon the selected input, one of the dialogs shown below will continuously scroll through the
screen.
4. This box also appears during normal system operation if the video cable becomes disconnected or damaged.
5. Turn off your monitor and reconnect the video cable, then turn on both your computer and the monitor.
If your monitor screen remains blank after you use the previous procedure, check your video controller and computer system; your monitor is functioning properly.
file:///T|/htdocs/monitors/1908WFP/en/ug/solve.htm[10/31/2012 11:34:36 AM]
safety instructions.
or
or