Table of Contents
Advertisement
Using the Cassette Deck
DOLBY B NR
REC PAUSE
CD REC
Things to Know Before You Start Recording ——————————————
Note: The first and end portions of the tape are called leader tape, which cannot be recorded onto.
CAUTION: If recordings you have made have excessive noise or static, the unit may be too close to
a TV which has been on during recording. Either turn off the TV or increase the distance between
the TV and the CA-MD9R.
54
EN.51-72.CA-MD9R[E]/F
DOLBY B NR
REC PAUSE
CD REC
PHONES
It may be unlawful to record or play back copyrighted material without the consent of the
copyright owner.
Press the DOLBY B NR button — the indicator lights up — to reduce tape hiss.
When you want to record onto both sides of a tape, turn on the auto reverse mode. However,
recording automatically stops after recording in the ¤ direction with the auto reverse mode on.
Therefore, make sure that the tape direction is ‹ when recording with the auto reverse mode
on.
The recording level is automatically set correctly, so it is not affected by the VOLUME control.
Thus, during recording you can adjust the sound you are actually listening to without affecting
the recording level.
Two small tabs on the cassette tape, one for side A and
one for side B, can be removed to prevent accidental
erasure or re-recording. To record on a cassette with the
tabs removed, you must cover the holes with adhesive
tape first. However, when a type II tape is used, only
cover part of the hole as shown, since the other part of
the hole is used to detect the tape type.
When recording, you can hear Sound Modes through the speakers or headphones. However, the
sound is recorded without Sound Modes (see page 9).
Type I and Type II tapes can be used for recording.
When you start recording, the first part of the recording may not be done because of this
leader tape. Before inserting the cassette, first wind the leader tape.
54
(Recording)
AUTO REVERSE
AUTO TAPE SELECTOR
DOLBY B NR
IMPORTANT: Before using the Remote Control for the
tape operations, set the Remote Control to the tape
operation mode by pressing the TAPE button.
6/16/98, 1:52 PM
¤ ‹ (Play)
7 (Stop)
Advertisement
Table of Contents
