Maytag MDG25PNAGW0 Installation Instructions Manual page 16

¢L_.UU COIN SLIDE OPTION
This option is either SELECTED 'ON' or NOTSELECTED 'OFF'.
Replacement of metercase will beneeded for coin slidemounting.
inn
o. u&_ Not Selected'OFF'.
o_ Selected'ON'.
NOTE: T his option needsto be setto '00' unlessthe
metercasehas beenchangedto accepta coin she device.
PressDELiCATES button3 consecutivetimes for this
selection.When coin slide mode is selected,set 'b.' equalto
vane of slide in coins. Set '6 xx' (REGULAR CYCLEPRICE)
and '3.xx' (SPECIALCYCLE PRICE)to number of slide
operations.6 01 & 3.01 = 1 slidepush.
NOTE:if the installersets up 'CS' on a coin drop model,
it will not register coins.
---> PressPERM.PRESSbutton onceto advanceto next code.
J_.uu ADD COINS OPTION
This option is either SELECTED 'ON' or NOTSELECTED 'OFF'.
This option causesthe customer displayto show the number
of coins (coin 1) to enter,ratherthan the amount.
cnn
_.._ Not Selected'OFF'.
c._ Selected'ON'.
PressDELiCATES button3 consecutivetimes for this selection.
PN MODELS: T his option is not selectable.
---> PressPERM.PRESSbutton onceto advanceto next code.
fF_ i
,-_d._c o COIN/DEBIT OPTION
II- I
,_,._ Bothcoin & debitselected.(NOTAVAILABLE)
fF
u._ Coins selected,debit disabled.
PressDELICATES button3 consecutivetimes for this selection.
f I
,.J.-L_o DebitCardselected,coin disabled.Defaultfor PN models,
and for PN operation,must be set as J._d.
PressDELICATES button3 consecutivetimes for this selection.
,.._._ EnhancedDebitis self-selected when a Generation2 card
readeris installedinthe dryer.The 'Ed' option cannot be
manuallyselectedor deselected. ( NOTAVAEABLE)
-e PressPERM.PRESSbutton onceto advanceto next code.
c_,ju u PRICE SUPPRESSION OPTION
This option is either SELECTED 'ON' OR NOTSELECTED 'OFF'.
This option causesthe customer displayto show 'AVAILABLE'
or 'ADD' ratherthan the amount of money to add. (Used
mainly in debit installations.)
I al"_
__. _ Not Selected'OFF'.
e c Selected'ON'.PressDELICATES buttononcefor this selection.
c._
---> PressPERM.PRESSbutton onceto advanceto next code.
_.c c
CLEAR ESCROW OPTION
This option is either SELECTED 'ON' OR NOTSELECTED 'OFF'.
Whenselected, m oneyheldin escrowfor 30 minuteswithout
further escrowor cycleactivitywill be cleared.
n._ Selected'ON'.
aa
n.&_ NotSelected 'OFF'.PressDELICATES buttononceto deselect
thisoption.
--> PressPERM.PRESSbuttononceto advance to nextcode.
, _ n n HUNDREDTH INCREMENT OFFSET
IUdU U
II I-I1-1
u. _ This represents t he hundredth incrementpriceoffsetused
in Generation 2 (Enhanced D ebit)PNmodelsset upwith card
reader.Choose from 0-4 hundredths bypressingthe WHITES
ANDCOLORS b utton.(NOTAVAILABLE)
--_ PressPERM.PRESSbuttononceto advance to nextcode.
If cycle counter (90C) is selected, the following is true:
1 O0 Represents the number of cycles in HUNDREDS. 1 02 = 200
2 O0 Represents the number of cycles in ONES. 2 2.5 = 25
TOTAL CYCLES = 225
This is 'VIEW ONLY' and cannot be cleared.
Press the PERM. PRESS button once to advance
to next code.
If money counter (1.0C or 1.00) is selected, the following is true:
3 O0 Currency amount in HUNDREDS. 3 01 = 100.00
4 O0 Currency amount in ONES. 4 68 = 68.00
5 O0 Currency amount in HUNDREDTHS. 5 7.5 = 00.75
TOTAL = 168.75
END OF SET-UP PROCEDURES
EXIT FROM SET-UP MODE
[] PD MODELS: Reinstall access door.
[]
[]
PN MODELS where AA1 plug was removed:
1. Unplug dryer or disconnect power.
2. Open console, reinsert jumper into AA1, close console.
3. Plug in dryer or reconnect power.
PN WITH PROGRAMMING SWITCH: Turn key clockwise and
remove.
If Service Access Code was used to enter set-up mode: From
Set-up Code 8, press button #1 for 4 seconds, wait 2 minutes
without touching any buttons (without diagnostic modes running),
or power down the dryer, then reapply power.
16