IMPORTANT
- PLEASE
KEEP FOR USE OF THE LOCAL ELECTRICAL
INSPECTOR
READ "SAFETY
PRECAUTIONS"
IN USE & CARE BOOK BEFORE
USING OVEN
In order to assure the best results in service, proper operation and maximum efficiency, the original installation and adjustment
should be made by your dealer, his authorized agent, or by your local utility company before you attempt to operate the oven.
LOCATION
Place oven where it will be welt lighted. For proper baking and cooking results, oven must be level. Use a spirit level on center
oven rack to level. THIS ELECTRIC OVEN IS APPROVED
FOR INSTALLATION IN COMBUSTIBLE
CABINETRY. SEE
INSTALLATION DIAGRAM FOR THE OVEN ON THE REVERSE SIDE OF THE INSTRUCTION
SHEET.
OUTSIDE
WIRING
Your local utility company will tell you whether the present electric service to your home is adequate. It may be necessary to
increase the size of the wiring to the house and service switch to take care of the electrical load demanded by the oven and/or
top section. The wattage (K. W. rating) load for the oven is specified on the name plate on the unit.
HOUSE WIRING
Most local building regulations and codes require that all electrical wiring be done by licensed electricians. All wiring should
conform to local or Canadian Electrical Codes. This oven requires a single phase 120/240 or a 120/208 volt, 60 Hz, AC circuit.
Wiring codes require that a separate circuit be run from the main entrance panel to the oven, The main entrance panel is to
be equipped with a separate disconnect switch and fuse as required by the local or canadian electrical codes.
RANGE CONNECTIONS
The flexible armored conduit supplied with the oven must be connected to the approved electrical breaker box supplied with
your oven. See figure number t.
FIGURE 1
WARNING:
Be sure OVEN IS DISCONNECTED
FROM POWER SUPPLY
BEFORE
EXAMINING
ANY OF THE
ELECTRICAL EQUIPMENT.
8101 P107-60
(6/94)