Westinghouse WTB2300 User Manual page 7

tEMpERAtURE CoNtRoL
Set the temperature by using the slide temperature control
in the main temperature control at slide temperature control
of the refrigerator compartment. When you first turn on the
refrigerator, set both the refrigerator and freezer temperature
control to MID.
TIPS & INFORMATION
Changing settings
When you change the temperature settings, make small
adjustments and wait 24 hours before assessing
whether you need to make any further changes.
REFRIGERAtoR tEMpERtURE ADJUStMENt
1. Select the refrigerator control.
2. S lide the control to the
left to set Colder.
3. S lide the control to the
right to set Less Cold.
ADJUStING tHE FREEZER tEMpERtURE
1. Select the freezer control.
2. S lide the control to the
left to set Colder.
3. S lide the control to the
right to set Less Cold.
TIPS & INFORMATION
Setting the freezer temperature to the lowest is not
recommended for normal or very hot climate condition as
this will limit the cooling capacity to other sections of the
refrigerator. In very cold climate, the freezer will need to
be set colder.
DooR ALARM
If the refrigerator door is left open longer than two minutes,
a buzzer will sound. Re-set the alarm by pressing the
light switch.
LIGHt bULb CHANGE
1. S witch off the power at the powerpoint
and remove the refrigerator's power
cord from the powerpoint.
2. Remove shelves and chiller
compartment.
3. Carefully unclip the light cover
by pulling the top of the cover
towards you.
COLDER LESS COLD
COLDER LESS COLD
4. U nscrew the light bulb and replace it
with a bulb of the same wattage and
type as the original. If, on removing
the light bulb, a small rubber 'O' ring
comes off with the bulb, fit this 'O' ring
over the new bulb and screw the bulb
back into the socket. See diagram
at right.
WARNING
Never insert your finger into the light bulb socket to check
for the presence of the 'O' ring.
5. Replace the light cover.
6. Replace shelves and chiller compartment.
7. Wait 5 minutes to ensure that pressure in the
refrigeration system is equalised. Then turn on the
refrigerator at the powerpoint.
FREEZER (wHERE FIttED)
1. S witch off the power at the powerpoint and remove
the refrigerator's power cord from the powerpoint.
2. Carefully unclip the light cover by pulling the top of the
cover towards you.
3. U nscrew the light bulb and replace it with a bulb of the
same wattage and type as the original. If, on removing
the light bulb, a small rubber 'O' ring comes off with
the bulb, fit this 'O' ring over the new bulb and screw
the bulb back into the socket. See diagram below.
WARNING
Never insert your finger into the light bulb socket to check
for the presence of the 'O' ring.
4. Replace the light cover.
5. Wait 5 minutes to ensure that pressure in the
refrigeration system is equalised. Then turn on the
refrigerator at the powerpoint.
TIPS & INFORMATION
Ensure that the 'O' ring is in place before replacing the
light bulb.
Light blub "O" ring Light socket
Installation 7