KitchenAid KHMS2056SSS4 Installation Instructions Manual page 5

4=
Secure vent deflector with 2 mounting screws (1 on each end).
A B
/co
4=
Position the damper assembly so that the long tab slides into
the slot on the right side of the damper vent opening, as
shown. Then secure with mounting screw.
A B C
A. Mounting screw
B. Damper assembly
C. Long tab (inside slot)
A. Mounting screw
B. Vent deflector
5. Replace vent screen.
Wall Venting Installation Only
To Remove Wall Damper Vent Cover:
1. Locate the wall damper vent cover on the back of the
microwave oven.
2. Using diagonal wire cutting pliers, gently snip out the damper
vent cover at the perforations.
A B C D
I oh .....
t, I- /
/
A. Diagonal wire cutting pliers
B. Back of microwave oven
C. Wall damper vent cover
D. Perforations
3. Save the cover for possible change of venting method in the
future.
Roof Venting Installation Only
To Remove Roof Damper Vent Cover:
1. Locate the roof damper vent cover on the top of the
microwave oven.
2. Using diagonal wire cutting pliers, gently snip out the damper
vent cover at the perforations.
A B C
D
A. Diagonal wire cutting priers
B. Top of microwave oven
C. Roof damper vent cover
D. Perforations
3. Save the cover for possible change of venting method in the
future.
NOTE: Do not install damper assembly at this time.