Optoma HD-3000 User Manual page 57

Removing and Installing the Lamp Unit
Follow these instructions to replace the lamp.
•
Remove the lamp unit by the handle.
projector.
•
To avoid injuring yourself and damage to the lamp, carefully follow the steps below.
•
Do not loosen other screws except for the lamp unit cover and lamp unit.
(Only the silver screws are loosened).
1. If the projector is running, press
turn off the power. Wait until the cooling fan stops.
Warning!
Do not remove the lamp unit from the projector imme diately after use. The lamp will be very hot and may
cause injury.
2. Disconnect the power cord and wait at least an hour for the lamp to cool.
3. Remove the lamp unit cover.
•
Loosen the user service screw that secures the lamp uni
arrow.
Do not to touch the glass surface of
on the projector or
EXIT
ECO
t cover. Then open the cover in the direction of the
M4* 8.9 screws
the lamp unit or the inside of the
on the remote control to
ENTER
STATUS
MENU
INPUT
57