2. SAFE INSTALLATION REQUIREMENTS FIRE, AND ELECTRICAL SHOCK HAZARD Installation and servicing of air-conditioning equipment can be hazardous due to system pressure and electrical Failure to carefully read and follow all instructions in this components. Only trained and qualified personnel should manual could result in furnace malfunction,...
Do NOT install the unit in a location that will permit - Platform must be high enough to allow for proper discharged air from the condenser to recirculate to the condensate trap installation and drainage. See Figure 2 and associated text for more information about condenser inlet.
supplied condensate trap that will allow a standing column of water of at least 2" (50.8mm) MUST be installed. Top of outlet from trap MUST be at least 1" (25.4mm) below top of REDUCED EQUIPMENT LIFE HAZARD outlet from unit. Install the trap as near to the unit as Failure to follow these precautions...
9. MAINTENANCE Check the unit's operation as outlined in the following instructions. If any unusual sparking, odors or unusual noises encountered, shut electric power MONTHLY MAINTENANCE AND INSPECTION immediately. Recheck for wiring errors, or obstructions in or CHECKS near blower motors. Air Filters 1.
Page 10
Motor removal and replacement 3, Disconnect all wires from housing and slide housing out of unit. Reverse this process to reinstall. This method is required to replace or repair blower wheel, Circulating Air Blower blower housing, or any unreachable components behind blower assembly.
Page 11
Control Box FIGURE Transformer Motor Board Control Plate Contactor Run Capacitor Capacitor Strap...
R GG NG INSTRUCTION rA_L_uRE -to fOLLOW THESE _NS-rRUC-r,ONS WARNNG RESULT IN PROPERTY DAMAGE, BODILY INdURY OR DEATH. - ALL PANELS MUST IN PLACE WHEN RIGGING LIFTING. - HOOK RIGGING SHACKLES THROUGH HOLES IN BASE RAIL, SHOWN IN DETAIL-A. - USE SPREADER BARS, WHEN...