Advertisement
LOCATION
OF YOUR WASHER
DO NOT INSTALL YOUR WASHER:
1.
In an area exposed to dripping water or outside
weather conditions.
Tile ambient temperature
should never be below 60 ° F (15.6 ° C) for proper
washer (detergent breakdown) operation.
2.
In an area where it will come in contact with
curtains or drapes.
3.
In an area (garage or garage4ype building) where
gasoline of other flammables are kept or stored
(including automobiles).
4.
On carpet. Floor MUST be solid with a maximum
slope of I/2 in. per foot (!.27 cm per 30.5 cm). To
ensure vibration
or movement
does not occur,
reinforcement of the floor may be necessary.
IMPORTANT
MINIMUM
INSTALLATION CLEARANCES
When installed
in alcove or dose8
Sides, Rear = 0 in. (0 cm)
Top = 0 in. (0 cm)
When installed
in closet:
Front = I in. (2.54 cm)
Closet door ventilation required; 2 Iouvered openings
each 60 in2(387 cm2),3 in. (7.6 cm) from top and bottom
of door.
6.
Remove the following from the back panel of the
washer:
4 packaging bolts,
2 packaging springs,
2 washers,
3 metal "P" clamps,
4 screws,
1 packaging brace.
7.
Remove the 4 transport plugs from the literature
pack and install them in the corresponding holes
in the back panel of the washer.
8.
Remove the 4 small hole plugs from the literature
pack and install them in the side panel holes
vacated by the packaging brace.
9.
Using the shipping posts, prop up the front of the
washer approximatley 2 inches to gain access to
the service panel screws.
10. Remove the 2 screws and remove the service panel.
UNPACKING
1.
Cut the shipping carton along the dotted line along
the base of the unit.
2.
While in the carton carefully lay tile washer on its
back side.
3.
Remove the styrofoam base.
4.
Carefully return the washer to an upright position
and remove the carton.
5.
Carefully move the
washer to within
4 feet (122cm) of
tile final location.
REMOVE TWO
UPPER BOLTS_
i',
'P'
CLAMPS_
i
AND
SPRINGS
_''
REMOVE LOWER
BOLTS AND
WASHERS
(2),
SCREWS (4)_
_!ii
AND BRACE
TWO SCREWS
UiNDER PANEL
LEFT
AND RIGHT
FOAM BLOCKS
11. Remove the the two (2) styrofoam blocks located
under the drum (a yellow ribbon surrounds the items
to be removed). Lift up on the drum, tilt the base of
the foam blocks inwards toward tile rear of the
washer until free, then pull them out.
12. Removeand discard the yellow ribbon from the front
of the washer.
13. Replace the service panel and screws.
NOTE:
If the washer is to be transported at a later
date, the shipping support hardware must
be reinstalled to prevent shipping damage.
Drain Hose tnstMtation
The drain hose isfield installed to allow hose orientation
to the left or right, up or down depending on location of
the house drain. Tile hose is shipped in the washer tub
with tile spring clamp on the coupler elbow and drain
hose hanger installed on the end of the hose.
.
2.
Remove tile drain hose from the tub of the washer.
Push the hose onto the drain coupler at the upper
left of the washer back panel until the hose con-
toots the STOP RIB.
Advertisement
