Hunter 99112 Installation

Installation
OFF
Before installing the
Remove the canopy. If uncertain
Universal Remote
how to remove it, reference the fan's
Control, use the pull
owner's manual. With wiring exposed,
chains to turn the light
it may be helpful to note existing wire
ON. Be sure power is OFF
connections or take a digital photo for
before proceeding with reference. Remove the wire connectors
installation. that connect the wires from the outlet
box to the fan, leaving the grounding
wires connected.
Wiring
blue (light out)
black (fan out)
white (common out)
CONNECT WIRES FROM RECEIVER TO FAN -Using the blue wire connectors connect the white wire from the
receiver (marked "common out") to the white wire from fan. Connect the black wire from the receiver (marked
"fan out") to the black wire from the fan. Connect the blue wire from the receiver (marked "light out") to the
blue wire (or possibly black with white stripe) from the fan.
Note: The red wire from the receiver has a pre-installed wire terminator. It will not be used.
If you're uncertain about wire colors or connections, please contact a qualified electrician.
Turn the splices upward and push them carefully back through the hanger bracket
into the outlet box. Spread the wires apart, with the grounded wires on one side of
the outlet box and the ungrounded wires on the other side of the outlet box.
Universal Ceiling Fan
Remote Control
Model #99112
Receiver
OR
Canopy
Choose the hanging system that most closely resembles the one used by your fan and install the receiver and wire as directed.
Note: Some fans may have considerable excess lead wire. For easier canopy installation, cut the excess wire, leaving a minimum of 8" remaining. Re-strip the fan lead wires 1/2" . Place remaining excess
wire into the ceiling electrical box. The bracket and fan must remain properly grounded.
You may have installation issues if the fan is installed on an angled ceiling.
blue
black
white
M0034-01 • 09/05/12 • © Hunter Fan Company
Receiver Ceiling
Plate
OR
Receiver
Canopy
Canopy
black (ungrounded) black (live in)
white (grounded) white (neutral in)
CONNECT WIRES FROM RECEIVER TO WIRES FROM OUTLET BOX - Using an orange wire connector connect
the black wire (ungrounded) from the ceiling to the black wire from the receiver (marked "live in"). Connect
the white wire (grounded) from the ceiling to the white wire from the receiver (marked "neutral in").
AFTER ALL WIRES ARE CONNECTED and secured with wire connectors, re-install the canopy.
To avoid possible electrical shock, before installing or servicing your fan, disconnect the
power by turning off the circuit breakers to the outlet box and associated wall switch
location. If you cannot lock the circuit breakers in the off position, securely fasten a
prominent warning device, such as a tag, to the service panel.
www.HunterFan.com
1.888.830.1326
For low pro le fans, the receiver should
be secured to the hanger bracket with
a cable tie.
Cable Tie
Ceiling
Bracket
OR
Receiver
Fan Body