Troubleshooting - Grundig FineArts ­55 ­FLE ­9170 ­SH User Manual

INFormAtIoN

troubleshooting

If the information provided below does not help, please consult an authorised GRUNDIG dealer.
Please bear in mind that malfunctions can also be caused by external devices such as video recorders
or satellite receivers.
problem
Screen lit (snow), but no s tation
visible
Insufficient contrast in picture
Picture and/or sound distorted
Ghosting, reflection
No colour
Picture but no sound
Teletext impaired or absent
The remote control does
not work
Picture too dark in PC mode
DMS device cannot be found
­ 7 4
ENGLISH
­---------------------------------------------------------------------------------------------------------------------
possible­cause
Antenna cable
No TV channel tuned
The picture settings are not correct
Problem at station
Interference from other devices
Channel setting
Antenna
Colour intensity too low
Adjust TV standard (if setting option is
available)
Problem at station
Volume is set to a minimum
Problem at station
Television channel (no teletext)
or antenna system
Station signal too weak
Obstacle between remote control and
device.
Battery problem
Operating mode undefined
Incorrect setting for picture resolution
and picture frequency on the PC
DMS device is not switched on or
not started
Network connection settings are not
made.
remedy
Is the antenna cable connected?
Start a channel scan
Adjust the brightness, contrast or c olour
setting
Try another channel
Place the device in a different position
Automatic or manual tuning/fine tuning
Have antenna cable or system checked
Turn up the colour
Select the correct colour standard
Try a different channel
Turn up or switch on the volume
Try a different channel
Try with a different TV channel,
carry out fine tuning
Check antenna
Point remote control at television
Check batteries and replace if
n ecessary
Switch off the television at the mains
switch for two minutes
Change settings on the PC
(e.g. 1280 x 768 resolution,
refresh rate 60 Hz)
Make sure that the DMS device is on
and operating.
Check the network settings.