Cleaning The Case; Cleaning And Replacing The Air Filter - Epson MovieMate 62 User Manual

Cleaning the Case

Before you clean the case, turn off the projector and unplug the power cord.
■
To remove dirt or dust, wipe the case with a soft, dry, lint-free cloth.
■
To remove stubborn dirt or stains, moisten a soft cloth with water and a neutral
detergent. Wring the cloth as dry as possible, then wipe the case.
Caution: Never use wax, alcohol, benzene, thinner, or other chemical detergents. These can
damage the case. Never spray cleaners directly on

Cleaning and Replacing the Air Filter

Clean the air filter and air intake vent when dust builds up or when you see the following
message:
The projector is overheating. Make sure nothing is blocking the air vents, and
clean or replace the air filter.
Dust clogs prevent proper ventilation, which can cause overheating and damage the projector.
1. Press the button on the control panel or the
the projector off. When you hear a short beep, disconnect the power cable.
2. Use a small vacuum cleaner designed for computers and other office equipment to clean
the filter, as shown.
If you cannot clean the removable filter or it is broken, you need to replace it.
You can purchase a new filter (part # V13H134A26) from an Epson authorized reseller.
To find the nearest reseller, call 800-GO-EPSON (800-463-7766). Or you can purchase
online at www.epsonstore.com
the projector
button on the remote control to turn
(U.S. sales) or www.epson.ca
.
(Canadian sales).
Caring for Your Epson MovieMate
55