Krups SUPERIORE Instructions For Use Manual page 13

Take out the drum.
Press the release key on the function lever
and then press the lever right down.
sieve, the brewing sieve ring and the
brewing sieve seal. Exchange the seal for
a new one and then replace all three parts
in the reverse sequence (30).
ns
PROBLEM:
The pump makes a loud noise.
POSSIBLE REASONS:
n No water in the water container.
can only develop a low pressure.
No espresso runs out.
POSSIBLE REASONS:
(see 'Lime-scale removal').
n Espresso meal too fine - mix it with
coarser meal.
drum, clean the brewing sieve,
screwing it off if necessary
(see 'Changing the brewing sieve seal').
(see 'Changing the brewing sieve seal').
PROBLEM:
Espresso has no crema.
POSSIBLE REASONS:
n Function lever not fully depressed.
PROBLEM:
Too little or no froth when frothing up.
POSSIBLE REASONS:
refrigerator temperature.
coffee-pot or pitcher.
different fat content.
PROBLEM:
Espresso coffee is too cold.
POSSIBLE REASONS:
(see 'Lime-scale removal').
PROBLEM:
Drum refuses to turn.
POSSIBLE REASON:
the previous espresso preparation
on the pump for ten seconds to clear.
PROBLEM:
Drum is difficult to turn.
POSSIBLE REASON:
drum - clean the drum.
switch
13