Cord Storage - Krups SUPERIORE Instructions For Use Manual

The frothing aid can be disassembled in
order to clean it properly, as follows:
n Pull the two parts A + C from the small
metal tube B (28).
Wash all three parts in warm water. If the
small suction orifice in part A has become
clogged, free it by poking a fine needle
through the blockage.
If the appliance is not to be used for a
lengthy period, the drum and discarded
coffee grounds holder should be thoroughly
cleaned and dried.
Before such a lengthy period of non-usage,
you can also drive off the water from the
heating system as steam. Place a container
beneath the steam nozzle and turn the
steam knob to @!3. As soon as no more
steam is generated, return the knob to the
3 position.
Switch off the appliance.
The machine must have lime-scale removed
regularly. For an average usage of 4 cups
daily and hard water, we recommend
descaling the appliance every three months.
The appliance MUST be descaled if the
espresso preparation time increases
noticeably or if the coffee temperature is
reduced.
Only the following are to be used as
descaling agents:
n Citric acid or
n Tartaric acid
Do not under any circumstances use the
conventional amidosulphonic acid or any
descaling agent using such, as these can
damage your appliance (check the
composition of any descaling agent which
you use).
12
Carry out the descaling operation as
follows:
Pull off the frothing aid.
1.
2. Dissolve 2 tablespoonfuls of citric or
tattaric acid (both obtainable from
chemists or drugstores) in 17 oz. of
lukewarm water and pour it into the
water container.
3. Place one container beneath the
espresso delivery pipe and another
beneath the steam pipe.
Switch on the appliance.
4.
As soon as the yellow heating indicator
5.
lamp ceases to glow, turn the steam
knob to - and then the pump switch to
the G position.
Allow about l/3 of the descaling solution
6.
to run through.
7. Move the pump switch to the
3 position.
8. Allow the descaling solution to work for
Now let a further third of the solution
9.
run through. Set the pump switch to the
3 position and turn the steam knob
also to position 3.
10. Press down the function lever to the
lowest position.
11. Move the pump switch to the L!
position and allow the rest of the
descaling solution to run through and
out of the espresso delivery pipe into a
container.
12. Finally allow one containerful of clear
water to run through in order to rinse
out the appliance.
13. Switch off the appliance and allow it to
cool down.
14. Push the frothing aid back onto the
appliance.

Cord storage

n Any excess cord length can be
accommodated in the cord storage at the
rear side of the appliance (29).