Krups SUPERIORE Instructions For Use Manual page 11

With this appliance you can prepare hot
water for making instant drinks and the like.
Make sure that the heating system is full of
water (see 'Filling the heating system with
water').
Start with the preparation of hot water as
soon as the yellow indicator lamp goes out.
Swing out the steam pipe and hold the
tallest possible cup beneath it.
n Turn the steam knob to - and the pump
switch to e (24).
When the hot water preparation is
complete, turn the pump switch to 0 and
the steam knob to 0. Then remove the
container.
After uie
To remove coffee residues from the inside
of the system, it is advisable to cleanse
through the appliance after use.
Do this as if you were making espresso, but
without using any coffee grounds.
Cleaning
Always pull out the mains plug before any
cleaning operation. Allow the appliance to
cool down. Clean the casing with a moist
cloth only.
The water container is to be emptied after
each usage.
The drum should be cleaned after about ten
runs through and in any case 2-3 times a
week and after any lengthy period of non-
use.
Before the drum is taken out for cleaning
purposes, one extra complete turn should
be made so that any residues of coffee meal
will be thrown out of the drum into the
discarded coffee grounds holder.
Then take out the drum as follows:
appears in the symbol panel (25).
Open the drum cover.
n Reach with the thumb into the depression
in the drum release and press the slide
towards the drum knob. Pull the drum
upwards by the drum knob and lift it out
of the appliance (26).
Press the release key on the function lever
and then press the lever itself right down,
thereby pushing out the piston, which can
now be more easily cleaned.
Rinse out the drum under running water.
Do not put it in the dishwasher!
Use washing-up liquid if the drum is very
dirty or for a thorough clean.
Wipe the inside of the appliance with a
moist cloth.
Replace the drum after drying it by first
pressing the slide towards the drum knob
and then inserting the drum from above
until it registers.
When inserting the drum, make certain that
the function lever is in the upper position.
Remove the cup grid and clean it.
Empty and clean the drawer and discarded
coffee grounds holder.
Rinse all loose parts under running water
and do not put them in the dishwasher.
Use washing-up liquid if the parts are very
dirty or for a thorough clean.
Clean the steam nozzle immediately after
frothing up milk by making steam for a
further l-2 seconds to blow out any residue.
Then wipe the nozzle with a moist cloth. If
the nozzle becomes clogged, clean it out
with a needle.
screwed off in an counterclockwise
direction using the hexagonal key on the
measuring spoon and then thoroughly
cleaned (27).
with the steam nozzle so do not
dismantle or assemble it while hot.
Screw the cleaned nozzle clockwise back
into position again and tighten lightly using
the hexagonal key.
11