Kenmore 79031033803 Installation Instructions Manual page 3

To avoid breakage: Do NOT handle or manipulate the unit by
the cooktop
glass.
The counter-top around the cut-out should be flat and leveled (see
hatched area on illustration 1).
Before installing the unit, measure the heights of the two (2) cabinet
sides (H1-4), front and back (see illustration 1) from the floor to the
top of the counter•
Level the range using the
four (4)leveling legs so
that the height from the
floor to the underside
of the cooktop glass is
greater than the tallest
cabinet measurement
by at least 1/16" (see
illustration 2).
Shave
Raised
Edge
to Clear
Space for a
311/2" (81 cm)
Wide Cooktop.
1 1/2"Max.
(3.8 cm Max.)
Illustration 1
Slide the unit into the cabinet. Make sure the center of the unit is aligned with the center of
the cabinet cut-out.
Remove the protective channels on each side of the glass cooktop
(if provided)•
The metal flange under each side of the cooktop MUST be placed
over the cabinet countertop for proper unit support• The glass
cooktop should NOT directly touch the countertop (see illustration 2)
or could cause glass breakage voiding the warranty• Level the unit if
needed•
After the installation, MAKE SURE that the unit
is supported by the leveling legs NOT by the
cooktop.
successfully install
the range, the initial
level height from
floor to underside of
cooktop glass should
be at least 1/16"
taller than cabinet
sides as measured in
step 1.
Illustration 2
3