Before You Start - Kenmore 721.86012 Installation Instructions Manual

YOUR SAFETY FIRST
BEFORE YOU START
* Proper installation is the installer's responsibility!
- Read the entire manual before you begin.
- The model number label is located on the oven front. See Figure 1.
- Mounting plate is located on back side of microwave oven. See Figure 2.
BE SURE TO READ THE FOLLOWING SAFETY iNSTRUCTiONS:
Model and Serial
Number Plate
Figure I
Mounting Plate
Mounting Plate
Figure 2
,A WARNING ,_k
FOR YOUR SAFETY:
* You will need TWO people to install this oven. It is heavy and could cause personal injury if not
handled properly. The dimensions of the oven are as follows:
Height : 16-7/16 inches
Width : 29-15/16 inches
Depth : 15-3/8 inches
• AVOID ELECTRICAL SHOCK!
- Before you drill into the wail, note where electrical outlets are and where electrical wires might
be concealed behind the wail.
YOU COULD GET AN ELECTRIC SHOCK if you contact electrical wires with your drill bit.
- Locate and disconnect the power of any electrical circuits that could be affected by installing this
ove n.
iF YOU DO NOT DISCONNECT THE POWER, YOU COULD GET AN ELECTRIC SHOCK.
• ELECTRICAL RATING OF THiS OVEN : 120V, 60Hz.
- You need a ] 20V, 60Hz, AC only, 20A, fused electrical supply (located in the cabinet above the
microwave as close as possible to the microwave circuit) serving only the microwave.
2