Kenmore 66512776K310 Installation Instructions Manual page 2

%Custom panel installatio
--:J Dishwashers with control
panel on the top
231/2" ,___
(59.7 cm) I *303Ae'' (76.7 cm)
3/4"(19.1 mm)
*This dimension is for 4" (10.2 cm) toe kick. If the
installation needs a higher toe kick, adjust the height
of the wood panel accordingly. Not recommended for
toe kicks greater than 6" (15.2 cm).
Attach handle
(15.2 mm)
Install the custom hardware handle(s) on the front of the
wooden panel inside dotted line.
IMPORTANT: If the handle is attached from the back of the
custom panel, the screw holes should be countersunk for the
screws heads to be flush with the panel. If the handle is
attached to the front of the custom panel, the screw lengths
cannot exceed the panel thickness.
Panel template
Using the template provided, attach it to the backside of the
custom panel with tape. Make sure that the center of the
template is aligned with the center of the wooden panel and top
of the template is aligned to the top face of the wooden panel.
Predrill custom panel holes
NOTE" Do not drill deeper then 5/8"(16 mm) to keep from drilling
through panel. Pilot hole depths given are for 3/4" (19.1 ram) thick
panel.
Mark 4 pilot holes on the wooden panel using the template
provided. Predrill 4 pilot holes using a 3/32"drill bit. Use tape to
mark the drill bit to gauge hole depth. Drill pilot holes
approximately 5/8" (16 mm) into the custom panel.
2