Wavetek 3SR Operation Manual page 125

Message ERROR... C/N cannot be measured on a scrambled
channel!
Condition
Response
Message ERROR... Hum cannot be measured on a scrambled
channel!
Condition
Response
Message SORRY... No more tilt channels can be
programmed.
Condition
Response
A channel that has been
programmed as scrambled in
setup has been selected in C/N
mode.
Select a channel that is not
scrambled. C/N measurements are
not possible on a scrambled
channel.
A channel that has been
programmed as scrambled in setup
has been selected in Hum mode.
Select a channel that is not
scrambled. Hum measurements are
not possible on a scrambled
channel.
The maximum number of tilt
channels has been reached.
To program another tilt channel, an
existing tilt channel must be
reprogrammed as a non-tilt channel.
B-7