Step 6 Placing The Dishwasher And - Samsung DMR78 Series Installation Manual

STEP 6 PLACING THE DISHWASHER AND CONNECTING WATER
SUPPLY LINE
1. Adjust the four leveling legs at the bottom of the dishwasher after measuring the height of the
cabinet opening from under the countertop to the floor. (Refer to the figures in STEP 7.)
2. Locate the water supply line for connecting the inlet valve on the left and the power cable for
connecting the junction box on the right.
3. Place the dishwasher so that the water supply line and the power cable are located in the
channels at the base of the dishwasher. Use standard duct tape to secure the water line and
electrical cable to their adjacent channels in the base.
4. Pull the drain hose through the hole in the side wall to the sink.
5. Slide the dishwasher carefully into the installation space.
6. Connect the water supply line into the elbow joint.
ADo not place the dishwasher on the water supply line, drain hose or power cable. Also,
....... make sure they are not folded or twisted.
<Figure 6> <Figure 7>
f l
Water supply line
E'll_ow
Inlet valve
12 installing the dishwasher