Samsung DMR78 Series Installation Manual page 16

3. Check the size of the sink's drain hose connector. If needed, cut the drain hose so its end
fits into the sink connector (1/2 in., 3/4 in. or 1 in. - as shown in the Figure below). If the
end of the drain hose does not fit into the drain hose connector of the sink, use an adaptor
purchasable at a plumbing/hardware supply store.
4. When connecting the drain hose, make sure to fasten it using a hose clamp. Failing to do so
may cause water leakage.
5. If there is no air gap, make sure to hang the middle of the drain hose in a high location to
prevent backflow (see the figure below).
ABe careful when cutting off the end of the drain hose as there is a risk of injury. Clean
....... around the sink's drain connection so that it does not damage the hose. Check for any
foreign items in the drain hose and remove them.
<Figure 11>
<Figure 12>
U
Sink
i i
ut off the end
of the drain hose at one
of the dotted lines.
Dishwasher
Drain hose
Min. 20 in.
(508 mm)
16 installing the dishwasher