Step 6 Placing The Dishwasher And - Samsung DMT800 series Installation Manual

STEP 6 PLACING THE DISHWASHER AND CONNECTING WATER
SUPPLY LINE
1. Adjust the three leveling legs at the bottom of the dishwasher after measuring the height of
the cabinet opening from under the countertop to the floor. (Refer to the figures in STEP 7.)
2. Locate the water supply line for connecting the inlet valve on the left and the power cable for
connecting the junction box on the right.
3. Place the dishwasher so that the water supply line and the power cable are located in the
channels at the base of the dishwasher. Use standard duct tape or cable tie to secure the
water line and electrical cable to their adjacent channels in the base. It can prevent the
squeeze of the water line and electrical cable when placing the dishwasher.
4. Pull the drain hose through the hole in the side wall to the sink.
5. Slide the dishwasher carefully into the installation space.
6. Connect the water supply line into the elbow joint.
_Do not place the dishwasher on the water supply line, drain hose or power cable. Also,
....... make sure they are not folded or twisted.
<Figure 6> <Figure 7>
r
Water supply line
Elbow( 3/8" (9.5ram}}
Inlet valve
12 instaling the dishwasher