Advertisement
Available languages
Available languages
Option 2, No waste disposer - with air gap:
1. Cut end of drain hose if needed (do not cut ribbed
section).
2. Attach drain hose to air gap with large spring-type
clamp.
If the drain hose was cut, use a 1-1/2" to 2"
(3.8 to 5 cm) screw-type
clamp*.
3. Use a rubber hose connector*
with spring or screw-
type clamps*
to connect air gap to waste tee.
This connection
must be before the drain trap and at
least 20" (50.8 cm) above the floor where dishwasher
will be installed.
drain hose-
cut here if needed
rubber hose
connector
gap
large
spring-type
drain
drain trap
_-.
hose
4.
Insert drain hose
through
hole cut in
cabinet to the front
center of opening
where drain
connection
will be
made.
drain hose
Option
3, Waste disposer
- no air gap:
1. Remove the disposer
knockout
plug. Do not cut end of
drain hose.
2. Attach drain hose to disposer
inlet with large spring-
type clamp.
This connection
must be before the drain trap and at
least 20" (50.8 cm) above the floor where dishwasher
will be installed.
It is recommended
that the drain hose
be looped up and securely fastened to the underside
of
the counter.
large spring-type
clamp
hose
3.
Insert drain hose
through
hole cut in
cabinet to the front
center of opening
where drain
connection
will be
made.
drain hose
Option
4, No waste disposer - no air gap:
1. Cut end of drain hose if needed (do not cut ribbed
section).
2. Attach drain hose to waste tee with 1-1/2" to 2"
(3.8 to 5 cm) screw-type
clamp*.
This connection
must be before the drain trap and at
least 20" (50.8 cm) above the floor where dishwasher
will be installed.
It is recommended
that the drain hose
be looped up and securely fastened to the underside
of
the counter.
drain hose -
_
cut here if needed
waste f
1
/'
_
"_
tee
_
I
L_¢'_
I
_t_.
[
_
[
I
E_
drain
[
k_
J
_
N
hose
3.
Insert drain hose
through
hole cut in
cabinet to the front
center of opening
where drain connection
will be made.
2 Parts available
from local
plumbing
supply
stores
drain hose
Prepare cabinet opening
where
there
are no existing
utility hookups
Electrical
connection
Option 1,
1.
2.
3.
4.
5.
Direct wire method:
HelpfulTip:
Wiring the dishwasher
will be easier if you
route wire into the cabinet opening
from the right side.
Drill a 3/4" (1.9 cm)
optional
preferred
hole in right-hand
locations
locations
cabinet side, rear or
floor. Preferred
and
optional
locations
are
shown.
Wood cabinet: Sand
hole until smooth.
Metal cabinet: Cover
hole with grommet,
not provided.
Run wire into house wiring
junction
box.
Install a UL listed/CSA
certified
clamp connector
(strain
relief) for flexible-type
wire. If installing
conduit,
attach
a UL listed/CSA
certified
conduit
connector
to the
junction
box.
Run other end of wire
through
cabinet hole.
Cable must extend to the
right front of cabinet
opening.
Advertisement
