Advertisement
Available languages
Available languages
2.
3.
With copper tubing
pushed into compression
fitting as
far as it will go, use a wrench
and tighten
compression
fitting
nut to elbow on water inlet valve. Do not use
Teflon <_ tape with compression
fittings.
Place paper towel under elbow.Turn
on water supply
and check for leaks.
Connect
to drain
1. To help minimize
vibration,
route drain hose to avoid
contact with motor, door springs, water
line, cabinet,
flooring
or the edge of the hole where it passes through
the cabinet.
2. Do not remove drain loop from side of dishwasher.
3. Place pan under end of drain hose. Pan will collect any
water in drain hose.
4.
5.
J
J',,
drain
hose
The drain hose molded end will fit 5/8" (16mm),
3/4" (19mm) or 1" (25.4mm)
diameter
connections
on
the air gap, waste tee or disposer.
Cut on the marked
line as required
for your installation.
IMPORTANT: Do not cut corrugated
portion
of hose.
cutting
lines
/
\
@
If a longer drain hose is required,
add up to 42"(1.07m)
of length for a total of 10 ft (3.05m) to the factory
installed
hose.
Use 5/8" or 7/8" inside diameter
hose and a coupler to
connect the two hose ends. Secure the connection
with
hose clamps.
Secure the drain hose to the air gap, waste tee or
disposer
with clamps.
NOTE:Total
drain hose length must not exceed 10 ft
(3.05m), for proper drain operation.
Oz
\
coupler
hose clamp
hose clamp
Secure
dishwasher
in cabinet
opening
Tip Over Hazard
Do not use dishwasher
until completely installed.
Do not push down on open door.
Doing so can result in serious injury or cuts.
1. If you have not already done so, open dishwasher
door,
remove lower dishrack and place towel over pump
assembly
and spray arm of dishwasher.
This will keep
screws from falling
into pump area if you
unintentionally
drop them when securing
dishwasher
to countertop.
2. Check that dishwasher
is still level and centered side to
side in the opening,
and that the tub flange aligns with
the front face of the cabinet frame.
3. Secure dishwasher
to countertop
with two, #8 x 5/8"
Phillips flat head screws.The
dishwasher
must be
secured to keep it from tipping
when door is opened.
4.
5.
/:
//
_top
Open door about 3" (7.6 cm) and check that space
between
inner door and tub is equal on both sides. If
spacing
is not equal, loosen bracket screws and shift
tub. Tighten
bracket screws.
Check that top of door does not contact screws,
brackets, or countertop.
If it does, dishwasher
must be
lowered
and re-leveled.
6. Remove towel from dishwasher.
7. Reinstall the lower dishrack.
13
Advertisement
