Advertisement
Available languages
Available languages
• Spring adjustment pinsshould beinthesame holes
onboththe leftandrightsides.
Move
dishwasher
into
cabinet
opening
1. Using two or more people, stand the dishwasher
up.
2. Grasp the sides of the dishwasher
at the edges of the
door panel.
3. Move dishwasher
close to cabinet opening.
Do not
push on the front of the panel or on the console-they
may dent.
4. If dishwasher
has a power supply cord, insert power
supply
cord into hole cut into cabinet.
If using direct wire, check that it is on the right front
side of opening.
5. Check that water line is on the left side of opening
and
drain hose is near the center of the hole in the cabinet.
6. Slowly
move dishwasher
completely
into cabinet
opening
so that the front corners of the dishwasher
door are flush with the cabinet doors. Do not kink or
pinch copper tubing,
drain hose, power supply
cord or
direct wire between
dishwasher
and cabinet.
HelpfulTip:
Once the dishwasher
is in position,
you
may have to support the front of the dishwasher
by
raising, lowering
or shimming
front feet.
7. Remove cardboard
from under dishwasher.
NOTE: It is all right if dishwasher
fits tightly
into cabinet
opening.
Do not remove insulation
blanket -the
blanket
reduces the sound level.
Level the dishwasher
1.
Align front of dishwasher
door panel with cabinet
doors.You
may need to adjust alignment
to be even
with your cabinets.
HelpfulTip:
Prop up one side of frame to hold
dishwasher
up off floor when adjusting
front legs.
With some installations,
it may be easier to adjust the
front leg using the 6" adjustable
wrench.
2. Check that leveling
legs are firmly against the floor.
3. Close and latch the door, and place level against the
front panel. Check that dishwasher
is plumb.
If needed,
adjust leveling
leg or add shims until dishwasher
is
plumb.
4.
Repeat
for other
side of dishwasher.
NOTE: Shims
must
be securely
attached
to floor to prevent
their movement
when
the dishwasher
is operated.
5.
Place
level against
top front opening
of tub. Check that
dishwasher
is level from side to side. If dishwasher
is
not level, adjust front legs up or down until dishwasher
is level.
Make
Electrical
Connection
Check "Electrical
requirements"
section.
You need to:
o have the correct electrical
supply and recommended
grounding
method.
If you are:
direct wiring,
use Option
1
using a power supply cord, use Option
2
Option
1, Direct wire
method
Electrical Shock Hazard
Electrically ground dishwasher.
Connect ground wire to green ground connector
in
terminal
box.
Do not use an extension
cord.
Failure to follow
these instructions can result in death,
fire, or electrical
shock.
1. Route direct wire so that it does not touch dishwasher
motor
or lower part of dishwasher
tub.
11
Advertisement
