Advertisement
Available languages
Available languages
2. Pull d irect w irethrough holeinterminal b ox.
3.
4.
5.
Helpful Tip:
o Select the proper size twist-on
connectors
to connect your household
wiring to 16-gauge dishwasher
wiring.
Insert wire ends into twist-on
connector.
Do not pre-twist
bare wire.
,Twist
connector.
Gently tug on wires to be sure both
are secured.
Connect the wires as follows
using twist-on
connectors
sized to connect direct wire to 16-gauge dishwasher
wire:
Power supply wire:
Terminal
box wire:
wh it e_,_-wh
ite
black_H_black
ground wire_,_ground
connector
ground
white
/
/_lack
Tighten
clamp connector
or conduit connector
screws.
Reinstall terminal
box cover with wires inside terminal
box.
The cover must be outside the box on the left side.
__
terminal
box cover
6.
Make
sure
no wires
are pinched
by cover.
Option
2, Power supply cord method
"a,
Electrical Shock Hazard
Plug into a grounded
3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension
cord.
Failure to follow
these instructions can result in death,
fire, or electrical
shock.
The power cord and connections
must comply
with the
National
Electrical
Code, Section 422 and/or local codes
and ordinances.
Recommended
power cord length is
54" min. and 64" max.
1. Remove terminal
box cover.
2. Connect incoming
power cord white (or ribbed) wire to
dishwasher
white wire, black (or smooth)
wire to black
wire and ground wire to dishwasher
green wire. Use UL
listed wire nuts of the appropriate
size for connections.
3. Replace terminal
box cover. Make sure wires are not
pinched
under the cover.
4. Plug power cord into a grounded
3 prong outlet.
5. Check the power supply cord does not touch
dishwasher
motor or lower part of dishwasher
tub.
Connect
to water
supply
Helpful Tip:
Compression
fittings:
a. Slide nut onto copper tubing
about 1" (2.5 cm).
b. Slide ferrule onto the tubing.
Do not position
ferrule
on the end of the tubing.
c. Put the tubing into the elbow as far as it will go.
d. Slide the nut and ferrule forward
and start the nut
onto the elbow threads.
Be gentle when handling
and positioning
the copper tubing,
it bends and kinks
easily.
nut
e ow.
1. To prevent vibration
during operation,
route the water
supply
line so that it does not touch the dishwasher
base, frame or motor.
12
Advertisement
