Door Reversal - Whirlpool WED97HEXL0 Installation Instructions Manual

DOOR RE %RS, (OPTION, }
The following instructions are for models with a round-shaped
door. For models with a square shaped door, an additional kit is
needed. Please contact your retailer, or see the For Assistance
or Service page in your Use and Care Guide.
Tools needed:
@
Min. 8" long Torx ®T25
screwdriver
#2 Phillips screwdriver
2, Move the door strike
®
®
®
®
®
®
®
®
Using a Torx ®* T25 screwdriver remove the 2 screws securing
the door strike to the door frame of the dryer. Rotate the
strike 180 ° and attach to the opposite side of dryer door
frame, as shown.
Using a Torx ®T25 screwdriver, remove the 4 screws securing
the door hinge to the dryer and lift up and out to remove the
door. Place the door on a soft towel or other non-scratch
surface. Reinstall the 4 screws in the holes.
Position the door with the inside of the door facing up.
Using a Phillips screwdriver, remove the 10 screws securing
the inner door to the outer door. Lift off the inner door and
set aside.
1 ® TORXis a registered trademark of Acument Intellectual Properties, LLC.
19