Advertisement
•
Lift range back panel up and off.
•
Assemble a UL listed conduit connector
in the opening.
Use Phillips screwdriver to remove screws and slide
cord/conduit
plate down and out.
Position cord/conduit
plate as shown in the following
illustration.
•
Replace cord/conduit
plate and insert screws.
A. Removable retaining nut
B. Strain relief
Feed the flexible conduit through the strain relief, allowing
enough slack to easily attach wiring to the terminal block.
Tighten strain relief screw against the flexible conduit.
5. Replace back panel and screws on rear of range.
6. Complete installation following instructions for your type of
electrical connection:
4-wire (recommended)
3-wire (if 4-wire is not available)
Electrical
Connection
Options
If your home has:
And you will be
Go to Section:
connecting to:
4-wire receptacle
A UL listed,
4-wire connection:
(NEMA type 14-50R)
250-volt
Power supply cord
minimum,
40-amp, range
power supply
cord
4-wire direct
A fused
4-wire connection:
disconnect
or
Direct wire
circuit breaker
(12.7
cm)
box
3-wire receptacle
A UL listed,
(NEMA type 10-50R)
250-volt
minimum,
40-amp, range
power supply
cord
3-wire connection:
Power supply cord
3-wire direct
A fused
_"
disconnect
or
(2.5c_,
circuit breaker
box
3-wire connection:
Direct wire
Advertisement
