Advertisement
Available languages
Available languages
INSTALLATION REQUIREME NTS
Gather the required tools and parts before starting installation.
Tools needed
•
Phillips screwdriver
Parts needed
•
A UL listed or CSA approved conduit connector
•
ULlisted wire nuts
Parts supplied
•
# 8-14 x 1" screws - single oven (2), double oven (4)
•
Bottom vent (supplied on some models)
•
# 8-18 x %" screws - bottom vent (supplied on some models)
Check local codes. Check existing electrical supply. See
"Electrical Requirements."
All electrical connections should be made by a licensed, qualified
electrical installer.
Make sure you have everything needed for correct installation. It is
the responsibility of the installer to comply with the installation
clearances specified in these instructions.
IMPORTANT: Observe all governing codes and ordinances.
Cabinet opening dimensions that are shown must be used. Given
dimensions provide minimum clearance with oven.
•
Recessed installation area must provide complete enclosure
around the recessed portion of the oven.
•
Grounded electrical supply is required. See "Electrical
Requirements" section.
•
Electrical supply junction box should be located 3" (7.6 cm)
maximum below the support surface when the oven is
installed in a wall cabinet. Drill a 1" (2.5 cm) minimum diameter
hole in the right rear or left rear corner of the support surface
to pass the appliance cable through to the junction box.
NOTE: For undercounter
installation, it is recommended
that
the junction box be located in the adjacent right or left
cabinet. If you are installing the junction box on rear wall
behind oven, the junction box must be recessed and located
in the upper or lower right or left corner of the cabinet;
otherwise, the oven will not fit into the cabinet opening.
•
Oven support surface must be solid, level and flush with
bottom of cabinet cutout. Floor must be able to support a
single oven weight of 123 Ibs (55.8 kg) or a double oven
weight of 222 Ibs (100.7 kg).
Undercounter
Installation
(with cooktop
installed
above):
Ovens approved for this type of installation have an approval label
located on the top of the oven. Refer to undercounter
installation
instructions for cutout dimensions and approved oven cooktop
combinations
(separate sheet).
Product Dimensions - Single Oven
A. 22%" (56.8 cm) max. recessed width
B. 29" (73.7 cm) max. overall height
C. 233/4'' (60.3 cm) overall width
D. 23" (58.4 cm) max. recessed depth
E, 27V2" (69.9 cm) recessed height
Installation Clearances - Single Oven
Single Oven Undercounter
(without cooktop installed above)
E
<
A
B
A. 24" (61 cm) min. cabinet width
B. 1W' (3.8 cm) min. top of cutout to
underside of countertop
C. 5V4" (13.3 cm) bottom of cutout to floor
D. 22W' (57.2 cm) cutout width
E. 273/4``(70.5 cm) min. cutout height
Advertisement
