GENTRON Pro2 Owner's Manual page 18

7500W Generator
Assembly
Wheel Kit Installation
1
3
5
Start by installing the
2
rubber floor mounts
onto the support leg
as shown.
Note: The leg should
be installed on the
same side as the pull
handle.
This is what the leg
4
looks like when it is
installed.
Slide the wheels
6
onto the axle. Place
a washer over the
wheel
18
Here is the hardware required to install
the support leg. Place a block of wood
under the generator so that you don't
have to hold it up while trying to install
the leg.
Place the support leg under the frame.
Push the bolt thru the frame and thru
the leg. Thread a nut onto the bolt.
Tighten with a wrench.
The wheels should be installed on the side
opposite to the handle.
Place a block of wood under the
generator so that you don't have to hold it
up while trying to install the axle.
Push the two axle mount brackets onto
each side of the axel. Place the axle under
the unit.
Thread two bolts thru the tubular frame
and thru the axle mounting plates. Thread
a nut onto the bolt and tighten.
Push the cotter pin thru
the axle and bend it
backwards as shown
Your generator is now
mobile. Enjoy!