Page 1
Installation Instructions For Heavy Duty Please read ALL instructions before installing. Two people are recommended to install this product. Ifa new electrical outlet WINDOW SASH SEAL is required, have the outlet installed by a qualified electrician before installing unit. See#5 in Preliminary Instructions following.
4. CHECK FOR ANYTHING THAT COULD BLOCK Tools Required AIRFLOW - check area outside of window for things a large flat blade screwdriver such as shrubs, trees, or awnings. Inside, be sure tape measure furniture, drapes, or blinds will not stop proper airflow. adjustable wrench or pliers pencil 5.
Page 3
Window Mounting Assemble Window Remove Chassis Filler Panels 1. Place cabinet on floor, a bench, or a table. STRAP/HANDLE NOTE: Do not use strap for lifting unit. It 2. Slide 'T' section of window filler panel into side retainer is for sliding chassis WITHIN cabinet only (to aid in cleaning, on the side of the cabinet (see Figures 2-3).
Page 4
Place Cabinet Install Support Window Bracket 1. Open window and mark 1. Hold each support bracket flush against outside of sill, center of window stool. and tight to bottom of cabinet as shown below. Mark brackets at top level of sill, and remove. MARK 2.
Page 5
Extend Window Filler Install Chassis into Panels Cabinet Install Front to Unit 1. Carefully raise window to expose filler panel locking 1. Lift chassis and carefully slide it into installed cabinet. screws. Loosen screws so filler panels slide easily. 2. _ DO not push on controls OR finned coils.
Thru-The-Wall Installation NOTE: Consult local building codes prior to installation, Carefully measure and cut an opening with t he following dimensions. See FIGS. 1 and 2. or a qualified carpenter. Select Wall Location WIDTH "X" = 26-3/4" (67.9cm) plus twice the thickness of framing material used.
Page 7
NOTE: If wall thickness is 8-1/2" or more, add aluminum flashing over bottom of frame opening to assure no water can FIG. 2 enter area between inner and outer wall. 1" LONG WOOD SCREW OPTIONAL: Support brackets may be used. Installation brakcets are recommended for walls under 5"...
OPTIONAL: Caulking and installation of trim on interior wall may be done. You can buy wood from your local lumber or hardware supply. On the outside, caulk openings around top and sides of cabinet, and all sides ofwtx_d sleeve to the opening. NOTE: See Step 7, Item 3 of Window Mounting Instructions for bottom rail seal location.