Advertisement
Attach foam adhesive
seal:
Attach foam adhesive seal along the bottom of the curtain bottom channel (FIG.8).
A. Curtain housing
B. Foam adhesive seal
FIG.9
A_g_ket fsCeacbuinee
tys eated
on edge of inner silt.
_binet
_'neUr°_,, wintdow [--J Bracket
outer sill
Install Cabinet
into Window:
1. Center empty cabinet in window:
FIG.10
I
I
A. Window sash
II
......................................
A
...................
B
......................
C
I
B. Empty cabinet
C. Window channel
Check that lower rail of air conditioner cabinet is behind and against back side of window sill. Maintain a firm hold on
the air conditioner cabinet (FIG.9). Lower window sash to hold the cabinet in place. Measure the distance between the
right side of the cabinet and the inside of the window channel (FIG.10). Repeat for the left side. Adjust the cabinet until
the distance on each side is the same.
2. Attach the cabinet to window:
A: For wooden window:
Use a 3/16" drill bit to drill three starter holes 3/8" deep through the three holes in the cabinet and into the window sill,
and drill one starter hole 318" deep through the hole in the middle of top rail and into the window frame (FIG.11). Attach
cabinet to window with three #10 x 1/2" pan-head Phillips screws and one #10 X 1/2" round-head screw (FIG.11).
B: For Vinyl-Clad
window:
Use a 1/8" drill bit to drill one hole through the hole in the middle of top rail and into the window frame. Attach cabinet
to window with one #10 x 1/2" round-head Phillips screw (FIG.11). Place two safety locks into the holes that located
in the bottom of the cabinet and drive two locking screws through the safety locks into the cabinet as shown (FIG.12)
3. Check that air conditioner cabinet is tilted back 5/16" to 3/8" so that water could run to the outside (See FIG.13).
FIG.11
.....
FIG.12
A
A
A. #10 X 1/2" pan-head Phillips screws
B. #10 X 1/2" round-head screw
C. Window channel
A,
B.
Only for Vinly-Clad Window
FIG.13
w Sash
',
ide Louvers
#10 X 1/4" pan-head Phillips screws
Safety Lock
Window Sill
Attach Side Curtains
to Window
Frame:
1. Extend the side curtains out against the window frame
(FIG.11).
2. Drill holes and drive locking screws:
A: For wooden
windows:
Use a 3/32" drill bit to drill 4 starter holes through the holes in
the side curtains into the window. Drive four #10 X 1/2" locking
screws through the holes in the side curtains into the window
sill and window frame(FIG.14A,
FIG.14B).
B: For Vinyl-Clad
windows:
Use a 118"drill bit to drill two holes through the holes in the
side curtains into the window frame as shown (FIG.14A).
Drive two #10 X 112" locking screws through the holes in the
FIG.14B
FIG.14A
B
_
A. Window channel
A. #10 X 1/2" round-head
B. left-hand curtain
C. #10 X 112" round-head
screw
B. Slotted hole in the
side curtains into the window sash (FIG. 14A)
screw
bottom of the curtain
3. Trim the weather seal (6"X314"X1112") with a proper length, peel off the protective backing and plug any gaps if
needed as shown (FIG.14B).
Advertisement
