This USE & CARE MANUAL provides specific operating instructions for your model. Use the room air conditioner only as instructed in this USE & CARE MANUAL. These instructions are not meant to cover every possible condition and situation that may occur. Common sense and caution must be practiced...
CAUTION. I Avoid Injury or damage to the unit or other property Provide occasional ventilation during use. Do not direct airflow at fireplaces or other heat related sources as this could cause flare ups or make units run excessively. Do not climb on or place objects on outdoor...
Record in the space provided below the model and serial numbers. On all models, the serial plate is located on the outside of the cabinet. Register Your Product The self-addressed PRODUCT REGISTRATION CARD should be filled in completely, signed and returned to the Frigidaire Company. Packaging Remove all packaging from inside the carton,...
Air Conditioner Features ELECTRONIC CONTROL Before you begin, thoroughly familiarize yourself with the control panel and remote as shown below and all its functions, then follow the symbol for the functions you desire. The unit can be controlled by the touch pad alone or with the remote. ADJUSTS TEMPERATURE DISPLAYS...
Page 6
Operating Instructions (continued) TO CHANGE TEHPERATURE SETTING: YOU WILL SEE: temp/timer temp//timer auto auto hi [] DO THIS: reed reed PRESS A TO RAISE PRESS V TO LOWER Note: Tap or hold either up ( A ) or down ( V ) button until the desired temperature is seen on the display.
Page 7
Operating Instructions (continued) TO OPERATE ON FAN ONLY: YOU WILL SEE: ternp/dmer temp/timer heat heat cool [] cool DO THIS: energy saver energy saver #n only PRESS [] fan only MODE BUTTON CHOOSE FAN ONLY Note: Use this function only when cooling is not desired, such as for room air circulation or to exhaust...
Page 8
Operating Instructions (continued) CHECK FILTER FEATUREr YOU WILL SEE; temp/timer temp/timer heat heat cool cool energy saver [] energy saver fanonly fan only PRESS FILTER DO THIS; RESET BUTTON Note: This feature is a reminder to clean the Air Filter (See Care and Cleaning) for more efficient operation. The LED (light) will illuminate after 250 hours of operation.
Page 9
If the display reads "HS", a sensor has If the display reads "AS", a sensor has If the display reads "ES", a sensor has failed. Contact your Authorized Frigidaire failed. Contact your Authorized Frigidaire failed. Contact your Authorized Frigidaire Service Center.
Page 10
Operating Instructions (continued) YOU WILL SEE: TO CHANGE TEMPERATURE DISPLAY: temp/timer mp/tim__/ DO THIS: PRESS AND HOLD THE UP/DOWN BUTTONS TOGETHER FOR 3 SECONDS Note: The control is capable of displaying temperature in degrees Fahrenheit or degrees Celsius. YOU WILL SEE: TO TURN UNIT OFF: hi []...
Operating Instructions (continued) The louvers will allow you to direct the air flow Up or Down and Left or Right throughout the room as needed. Rotate the Auger Wheel until the desired direction is obtained. AUGER WHEEL Care and Cleaning Clean your air conditioner occasionally to keep it looking new.
Page 12
Room too cold. Set temperature too low. Increase set temperature. Remote Sensing activated (on some models) and remote control located in Hot Spot - Relocate remote control or deactivate remote sensing. If These Solutions Fail, Call 1=800-944=9044 For Frigidaire Service,...
Page 13
Your appliance is covered by a limited one-year warranty and a limited 2-5 year warranty on the sealed system (the compressor, condenser, evaporator and tubing). For one year from your original date of purchase, Electrolux will pay all costs for repairing or replacing any parts of this appliance that prove to be defective in materials or workmanship when such appliance is installed, used and maintained in accordance with the provided instructions.