Advertisement
Wall Sleeve
Brands:
#3 Fedders or Friedrich
16=3/4" Deep
1. Remove existing rear grille as shown on Page 3 of this manual and
replace with provided Iouvered rear panel. Install as shown here.
NOTE: You may need to drill holes in flange of existing sleeve to match
new rear grille
2. Attach (2) 4½" x 3 ½" x 1Y," centering/support
blocks one on each
side wall. Place in center of side wall with the tapered end facing the
opening.
.
Cut (2) 17" Tapered Spacer Blocks as shown below into two pieces.
I i
17
_ _
J,
v
_
-
1"
3-/4,,I,
Tapered
Spacer
Bilock
j
' '_'-_pm I -"
12-1/2"
\i2 1/2"1" --
uu_ Mere.
-
_
protection Paper Backing
.
The 2½" section is placed in front of the rib on base with the tapered
end facing the back of the sleeve. Cut the remaining portion to 12W'
and place behind the rib again sloping toward the rear of the sleeve.
This helps induce a rearward slope on the unit.
5. Attach (1) l"x 3/8" x 25" long seal in the center at the top of the sleeve.
Remove the backing paper and press into position.
6. Attach (2) l"x 3/8" x 14" seals to the left and right sides of the sleeve.
7. Cut (2) 1" x 3/8" x 25" long seals to 14" long each and attach to the
vertical sections of the grille as shown.
8. Gently slide unit into sleeve.
9. Before sliding all4he-way back, remove 2nd screw from front on left side
of unit.
10. Remove the plastic washer from the screw.
11. Screw and attach the other end of the ground wire from sleeve to the unit
as shown in picture. Make sure that the toothed washer is against the
cabinet.
12. Slide the unit completely to the rear to ensure a good seal, making sure
the ground wire does not become tangled.
13. Seal & Frame the unit as described on the last page of these instructions.
14. If you have difficulty with mounting the grill to the sleeve, follow the
instructions for direct mounting on Page 13.
80 ° \
Rear Louvers
4s"
"
,,,,,,,,,,,,,,,,,,
50o
Top View
Advertisement
