Advertisement
NOTE:
If wall thickmess is 8-1/2" or more, add alumimnn
flashing over bottom of fimne opening to assure no water
can enter area between
inner and outer wall.
1"LONG
WOOD SCREW
FIG°2
AL[JMINUIM FLASHING
O_ER
BOTTOM
OF FRAME
Prepare
and
lasta
Cabiaet
Refer to Step 4 of Window Mounting _br assembly of
support bmckets.A wooden strip nailed to the outside
wall should be used in conjunction
with sill support
angle brackets.
1. Slide chassis fiom cabinet. Reier back to Step 1 of
Window Mounting.
2. Place cabinet into opening with bottom rail resting
_kmly on bottom board of wooden fiame.
3. Position cabinet to achieve proper slope for water removal.
(See FIG. 1 below.)
FIG°I
5/16"
TO
3/8"
3/4"PLUS
--TRIM
THICKNESS
SEE PARA 5
brakcet
Wooden strip
5. Screw or nail cabinet wooden frame using shims if
fiame is oversized, to eliminate distortion. Remember
to maintain proper slope as described in Step 3.
LEVEL
I
4. Secure bottom rail to wood flame with two large wood
screws i"(2.5 cm)long using the two holes m the bottom
of the chmmel resting on fimne.(See FIG.2 _bllowing)
6. Install chassis into cabinet by following all steps in
Step 8 of Window Mountmg.(continued)
Advertisement
