Advertisement
3. Insel_ top and bottom legs of window filler panel flmne
into chmmel in the to angle and bottom rail. Do both
sides.
4. Insert washer head locking screws (2) into holes in
top leg of filler panel flame (see Step 6). Do not totally
tighten. Allow leg to slide freely. Screws will be
tightened after Section 6.
Place
Cabinet
in
1. ()pen window and mark
center of window stool.
Rnstal!
Support
1. Hold each support bracket flush against outside of sill,
and tight to bottom of cabinet as shown below. Mark
brackets at top level of sill, and remove.
MARK
2. Place cabinet in window with bottom stool angle tS*mly
scated over window stool as shown. Bring window
down temporarily behind top angle to hold cabinet in
place.
3. Shift cabinet left or right as needed to line up center of
cabinet on center line marked on stool.
4. Fasten cabinet to window stool with 2 screws into
holes.(You may wish to pre=drill pilot holes.)
5. Add bottom rail seal over screws to window stool.
m
t I
__i!ii}}}i_.i_i{.i_i{.i_i{.i_i{.i_{iil![!i;_!ii!ii!ii!ii!ii!ii!ii!i_;_i_(
(
--]
}
w'
FLAT HEAD BOLT
<_li_
_J
2 EACH REQ'D FOR EACH
SL PPORT BRA(KET
2. Asscmble sill angle bracket to support brackets at the
marked position, as shown. Hand tighten, but allow
_br any changes later.
3. Install support brackets (with sill angle brackets
attached) to correct hole in bottom of cabinet as shown.
4. Tighten all 6 bolts securely.
v" tong screws
and locknuts
Advertisement
