Advertisement
Remove
Chassis
1. 1hill down ftont panel axt remove filter. (See FIG. !).
2. Lift ftont upwards and place to one side.
lnstatm Top Angl÷
and Side Bracket
Attach tbam gasket to top angle above holes as
shown in FIG. 6.
3. Locate file fimr flont screws _md remove. These screws will
be needed to re=install the flont later. (See f'IG.2)
4. PU away flont flom cabinet sides as per photo (see FIG.3)
5. Gently lift flont offunit and place to one side (See FIG.4).
2. Install top
gmgk grad
side retainers
to cabinet as
shown in FIG. 6.
2.
6. Remove shipping crews flom top ofumt grad also on the side
by the base if installed.
7. Hold the cabinet wNle pulling on the base hgmdle, grad care-
fillly lemove the unit.
8. Add two i[)_un inserts to holes in top of cabinet where
shipping screws were removed flom.
Assemble
Window
Fill÷r
Panels
Place cabinet on floor, a bench, or a table.
Slide 'T' section of window filler panel into side retainer
on the side of the cabinet (see Figures 7°8). Do both
sides.
FIG. 7
PLASTI(
\r_TNDOV, FILLER
FRAME
PANEL
9. Your unit may come wifil internal packaging.THIS
PACKAGING MUST BE P,EMOVED PRI()R T()
INSTALLING THE AIR C()NDITIONER
BACK
INT() THE CABINET. (See HG. 5)..
FIG. 8
d
[3
SIDE
RETASNER
i
AIR ( O)q)ITIONE_
CABE','ET
TOP
VIEW
T' SECTION
PLASTIC
FRAME
WENT)OW
HOLE
FILLER
PANEL
Advertisement
