Ford 2006 Milan Owner's Manual page 46

Lights
Replacing rear turn signal bulbs
1. Make sure the headlamp switch is
in the OFF position and open the
trunk.
2. A hard carpet shingles a soft
carpet at lamp area. Carefully
pull/push the soft carpet outboard
to expose the lamp assembly.
3. Remove the bulb socket by
rotating it counterclockwise, then
pulling it out of the lamp assembly.
4. Pull the bulb from the socket and push in the new bulb.
5. Install the bulb socket into the lamp assembly by rotating it clockwise.
6. Carefully push the soft carpet back to the shingle position to the hard
carpet.
Replacing backup lamp bulbs
The backup lamp bulbs are located in the trunk lid.
1. Make sure headlamp switch is in OFF position and open trunk to
access the lamp assembly.
2. Position the decklid trim aside by removing 3 to 4 pin-type retainers
to expose the lamp assembly.
3. Remove the bulb socket by
rotating it counterclockwise, then
pulling it out of the lamp assembly.
4. Pull the bulb from the socket and
push in the new bulb.
5. Install the bulb socket into the
lamp assembly by rotating it
clockwise.
6. Carefully reposition the trim back
to its original position and secure
the retainers.
46
2006 Milan (mln)
Owners Guide (post-2002-fmt)
USA (fus)