Technical Specifications - Ford Fiesta Owner's Manual

WARNINGS
Make sure there is no lubrication
(grease or oil) on the threads or the
surface between the wheel studs
and nuts. This can cause the wheel nuts
to loosen while driving.
Do not fit run flat tyres on vehicles
that were not originally fitted with
them. Contact an authorised dealer
for more details about compatibility.
WARNINGS
Do not install alloy wheels using
wheel nuts designed for use with
steel wheels.
Wheel nuts are subject to change.
You must make sure that you use
only the specific wheel nuts and
wheels supplied for your vehicle. If in doubt
please contact your authorised dealer.
Note: The wheel nuts of alloy wheels and
spoked steel wheels can also be used for
the steel spare wheel for a short time
(maximum two weeks).
Note: Make sure the wheel and hub contact
surfaces are free from foreign matter.
Note: Make sure that the cones on the
wheel nuts are against the wheel.
1. Install the wheel.

TECHNICAL SPECIFICATIONS

Wheel Nut Torque
Wheel Type
Wheels and Tyres
All
2. Install the wheel nuts finger tight.
3. Install the locking wheel nut key.
4. Partially tighten the wheel nuts in the
sequence shown.
5. Lower your vehicle and remove the
jack.
6. Fully tighten the wheel nuts in the
sequence shown. See Technical
Specifications (page 179).
7. Install the wheel trim using the ball of
your hand.
WARNING
Have the wheel nuts checked for
tightness and the tyre pressure
checked as soon as possible.
lbf.ft (Nm)
100 lbf.ft (135 Nm)
179