Engine Coolant Check; Brake And Clutch Fluid Check; Washer Fluid Check; Adding Engine Coolant - Ford Fiesta Owner's Manual

ENGINE COOLANT CHECK

WARNING
Do not allow the fluid to touch your
skin or eyes. If this happens, rinse the
affected areas immediately with
plenty of water and contact your doctor.
Note: Make sure that the level is between
the MIN and the MAX marks.
Note: Coolant expands when it is hot. The
level may therefore extend beyond the MAX
mark.
If the level is at the MIN mark, add coolant
immediately.

Adding Engine Coolant

WARNINGS
Only add coolant when the engine is
cold. If the engine is hot, wait 10
minutes for the engine to cool down.
Do not remove the filler cap when
the engine is running.
Do not remove the filler cap when
the engine is hot. Wait for the engine
to cool down.
Undiluted coolant is flammable and
may ignite if spilt on a hot exhaust.
Note: In an emergency, you can add just
water to the cooling system to reach a
vehicle service station. Have the system
checked by an authorised dealer as soon as
possible.
Note: Prolonged use of incorrect dilution
of the coolant can cause engine damage
from corrosion, overheating or freezing.
Note: Do not add coolant further than the
MAX mark.
1. Remove the filler cap. Any pressure will
escape slowly as you unscrew the cap.
Maintenance
2. Add a 50/50 mixture of coolant and
water using fluid that meets the Ford
specifications. See Technical
Specifications (page 165).
3. Replace the filler cap. Turn it until you
feel a strong resistance.
BRAKE AND CLUTCH FLUID
CHECK
Use of any fluid other than the
recommended brake fluid may
reduce brake efficiency and not meet
Ford's performance standards.
Do not allow the fluid to touch your
skin or eyes. If this happens, rinse the
affected areas immediately with
plenty of water and contact your doctor.
If the level is at the MIN mark, have
the system checked by an authorised
dealer as soon as possible.
Note: Keep brake fluid clean and dry.
Contamination with dirt, water, petroleum
products or other materials may result in
brake system damage and possible failure.
Note: The brake and the clutch systems are
supplied from the same reservoir.
Add fluid that meets the Ford specification.
See Technical Specifications (page 165).

WASHER FLUID CHECK

Note: The reservoir supplies the front and
rear washer systems.
When adding fluid, use a mixture of washer
fluid and water to help prevent freezing in
cold weather and improve the cleaning
capability. We recommend that you use
only high quality washer fluid.
152
WARNINGS