Ford 2013 Fusion Owner's Manual page 101

Keys and Intelligent Access
Message
Press Brake to START
No Key Detected
Restart Now or Key is
Needed
Run Power Active
Starting System Fault
Press Brake and Clutch
to Start
Press Clutch to Start
Cranking Time Exceeded
Key Program Successful
Key Program Failure
Max Number of Keys
Learned
Not Enough Keys
Learned
Key Battery Low Replace
Soon
Could Not Program
Integrated Key
Engine On
Fusion/Mondeo (CC7)
Information Displays
Displayed as a reminder to press the brake while starting the
Displayed if the key is not detected by the system. See
Keyless Starting (page 144).
Displayed when the StartStop button is pressed to shut off
the engine and an Intelligent Access key is not detected inside
Displayed when the vehicle is in the run ignition state.
This message is displayed when there is a problem with your
vehicle's starting system. See your authorized dealer for
Displayed as a reminder to press the brake and clutch while
Displayed as a reminder to press the clutch in while starting
Displays when the starter has exceeded its cranking time in
attempting to start the vehicle.
Displayed during spare key programming, when an intelligent
access key is programmed to the system.
Displayed during spare key programming, when an intelligent
access key has failed to be programmed.
Displayed during spare key programming when the maximum
number of keys have been programmed.
Displayed during spare key programming when not enough
keys have been programmed.
Displays when the key battery is low. Change the battery as
Displayed when an attempt is made to program a spare key
using two existing keys.
Displays to inform the driver that they are exiting the vehicle
98
Action
vehicle.
the vehicle.
service.
starting the vehicle.
the vehicle.
soon as possible.
and the engine is on.