Page 1
MnstaJJation Mnstructions GJassWaJJ Mount Range PHW ModeJ Series Pa_ No. 101745 Rev. F...
Page 2
Keep these installation instructions for future reference and the local electrical inspector's use. if You Need Help... If you have questions or problems with installation, contact your Dacor dealer or the Dacor Customer Service Team. For repairs to Dacor appliances under war- ranty call the Dacor Distinctive Service line.
Page 3
Use common sense and caution when installing, maintaining or operating this or any other appliance. Always contact the Dacor Customer Service Team about problems and conditions that you don't under° stand. DANGER...
General Safety Precautions To reduce the risk of fire, electric shock, serious injury or death when using your appliance, follow basic safety precau- tions, including the following: WARNING Do not install or operate this hood if it has been damaged, dropped, has damaged electrical wires or is not work- ing properly.
If mounting the range hood to dry- wall, Dacor strongly recommends the Blower 600 CFM max. using an anchoring system designed for use with drywall. In addition, Dacor Blower Speeds 4 with electronic speed control strongly recommends that you install a Lights...
When planning new Electrical Specifications duct work, always look for the shortest, most WARNING direct route to the out- side. Venting can be The e!ectrical serVic the range hood shou!d done through the roof installed only by a licensed electrician. or directly through the back wall to the out- It is the owner's responsibility to ensure that the electrical...
WARNING Do not install the range hood unless the power supply provided meets the required Electrical Specifications (see page 4). Observe all governing codes and ordinances during installation. Contact your local building department for fur- Lherinformation. A qualified technician must complete the installation of this buHtdn appliance. The owner is responsible to make sure the hood is propedy installed.
Page 8
JnstaJJing the Chimney Mounting JnstaJJing the BJowerMounting Bracket Bracket Determine the vertical center line for the range hood. Find the mounting bracket template in the shipping The center line for the hood is usually the same as box. Put the template against the wall and line up the horizontal line drawn on the wall with the horizontal the center line of the range or cooktop.
If mounting the hood to brick or masonry: Installing the Duct Work Drill five 5/16" X 1 1/2" holes in the locations marked. iMPORTANT - The installed duct work must: Be centered on the vertical center line drawn on the Insert five of the provided wall anchors into the .
Insert two provided machine screws into the two Hanging the Blower Assembly holes above the mounting bracket on the blower assembly and tighten into place. Insert two machine screws through the front of the mounting bracket and tighten into place. Insert two machine screws through the side of both "L"...
Electrical Connection installing the Chimney iMPORTANT: Be careful not to pinch the electrical wires WARNING while installing the chimney. To avoid electrical shock or fire hazard, make sure Remove the protective plastic covering from both the power supply at the fuse or junction box is pieces of the chimney assembly.
Page 12
installing the Chimney (Cont.) Installing the Glass Hood Carefully put the chimney over the blower assembly, taking care not to scratch the surfaces. Make sure the wiring is tucked in behind the chimney. o peopiel stance Lock the tabs inside the chimney bottom into the slots on the bottom of the blower assembly.
Repeat the above test. cable electrical codes (see pages 4 and 9)? If the hood still does not work, contact Dacor Distinctive Service at (877) 337_3226. Do not attempt Is the tempered glass hood attached to the blower to repair the appliance yourself.
Page 15
® The Life of the Kitchen? Dacor o 600 Anton Blvd. Suite !000 Costa Mesa, CA 92626 o Phone: (800) 793-0093 o Fax: (626)403-3!30 o www.Dacor.com...