Table of Contents
Advertisement
Trouble-shooting Answer to question
(If there's breakdown, please pull off the power plug before checking) The following
phenomena are not breakdowns sometimes. Please confirm again before sending it to
repair. If there are real breakdowns, please come to the special maintenance department
or after-sale service department of our company. Do not repair it by yourself.
Phenomena
In wash/rinse/spin, the machine stops
running. (The "wash" "rinse" "spin"
indicator flash quickly)
The draining does not work, or the
speed of draining is too slow (the
indicators of "wash" "rinse" flash)
The safety switch acts. The spinning
can not work (the indicators of "wash"
"rinse" flash quickly)
The water filling does not work
(the
indicators of "wash" "spin" flash quickly)
Not wash
The machine
does not act.
Not spin
There's abnormal sound inside the
machine
The water faucet leaks
No water inlet
Common phenomena
Phenomena
The spinning is intermittent when it starts.
Push the "FUNCTION" button to select "Spin", but it
doesn't work.
There may be some water flowing out of the drain
hose in the first use of the machine.
In the final spinning, it stops and displays "Rinse",
and starts water inlet.
The reason
The top lid is not closed
Is the drain hose blocked by
foreign material?
Are the laundries put slantingly?
Is the machine slanting?
The water faucet is not open
The water inlet valve is blocked
The water pressure is too low and
the current is too small
Is there power failure?
Is the power plug loose?
Does the water level arrive at the
set water level?
Is the power plug loose?
Is the top lid closed?
Are the laundries put orderly?
Is the machine slanting?
Are the laundries slanting in
spinning?
Is the jointer screw of the water
inlet hose is loose or twisted awry?
Is the power plug tightly plugged?
Is the water faucet open?
Have you pushed down the power
switch and Start/Pause button?
Balance the laundries to avoid slanting.
The program is setting the drain time. Some time is
needed before it starts spinning.
It is the water remained in the factory inspection of
performance.
It is because that the laundries are slanting to one
side, and the safety switch acts. After water inlet and
stirring, the slanting will be removed and the
spinning will work.
How to settle
Close the top lid
Clean the foreign material. Open
and close the top lid once.
Re-order the laundries. Close the
top lid.
Level the machine in right
position. Open and close the top
lid once.
Open the water faucet. Push the
"Start/Pause" button.
Clean the water inlet valve. Push
the "Start/Pause" button.
Wait for the normal water
pressure before use.
Use it when the power on.
Insert the power plug tightly.
Affusion to the water level.
Insert the power plug tightly.
Close the top lid.
Put the laundries orderly.
Level the machine properly.
Re-order the laundries.
Fasten the jointer screw
properly.
Insert the power plug tightly.
Open the water faucet.
Push down the power switch and
Start/Pause button.
Explanation
Advertisement
Table of Contents
