Table of Contents
Advertisement
checked periodically and replenished to maintain correct depth as determined necessary for your equipment. The choice of a
material depends on the type and height of the playground equipment, the availability of material in your area and its cost.
(The information above has been extracted from CPSC documents 'Playground Surfacing – technical Information guide" and
"Handbook for public Playground Safety." Copies of these documents can be obtained by sending a postcard to the: Office of
Public Affairs, USCPSC, Washington D.C., 20207 or by calling 1-800-638-2772.
•
Check all nuts and bolts twice monthly during the usage season for tightness and tighten as required. It is particularly
important that all nuts and bolts are checked prior to the first use each season.
•
For extended use, remove plastic swing seats and take indoors when the temperature drops below 32º F.
•
Oil all metallic moving parts monthly during the usage season.
•
Check all coverings for bolts and sharp edges weekly during usage season to be certain they are in place. Replace as
needed. It is particularly important that all coverings are checked prior to the first use each season.
•
Sand any rusted areas of the tubing and repaint with a non-lead based paint meeting the requirements of Title 16 CFR
Part 1303.
•
Check swing seats, ropes, cables and chains monthly during usage season for evidence of deterioration. Replacement
should be made in accordance with manufacturer's instructions.
•
Place your swing set a MINIMUM of six (6) feet from any other hard or fixed object.
•
Do not place your swing set underneath electrical lines. If you must, ensure that there is a minimum overhead
clearance of six (6) feet.
•
Please note the CPSC surfacing materials recommendations on page 3.
Your swing set comes with two 5mm Allen wrenches for the assembly of most of this product. You may also need to have an
adjustable wrench and a Phillips head screwdriver.
Although we take pride in the quality of our swing sets, on occasion there may be a burr or rough part which will require a metal
file to remove before use.
Main Frame
Name
Top Bar
Corner Leg Fitting
Leg
Support Bar
Slide
Name
Rail/Ladder Leg
Front Leg
Slide
Ladder Step
Slide Link Bar
5
CARE AND MAINTENANCE
LOCATION AND PLACEMENT OF YOUR SWING SET
TOOLS REQUIRED FOR ASSEMBLY
PARTS LIST FOR SWING SET
Each
2
2
4
2
Each
2
2
1
2
2
Glider
Name
Glider Pole (vertical) with Foot Rests
Glider Pole (horizontal) with Seats
Glider Frame Attachment
Swings and Trapeze
Name
Swing Seat with Chains
Trapeze with Chains
See-Saw
Name
See-Saw Seat
See-Saw Top Tube w/Pivot Bracket
See-Saw Frame
See-Saw Tube Extension
Each
2
2
1
Each
2
1
Each
2
1
1
1
2006 Pacific Cycle, Inc.
©
Advertisement
Table of Contents
